The effect of heavy & sustained rains on fallout dust monitoring.

The effect of heavy & sustained rains on fallout dust monitoring.

 

During weather of this type we note:
– General dust levels of agricultural, topsoils or other environmental dusts are lower due to the sources being saturated rather than the water droplets milking out the airborne dust.
– Production dust, however, is not greatly affected as any crushing, blasting or milling operation will still generate dust.
– Because of the above 2 factors the content of fallout dust will now have higher production dust as a percentage content but less in terms of the total dust concentration (the agricultural soil dust is almost non-existent).
– Organic debris will be lower as well.
– Pulverised roadway generated dusts will be lower or almost absent except where heavy traffic dried the surface.
– The sustained rainy & wet conditions have been extensively studied in the Western Cape area which has such rains during winter periods.
– Results can be in the order of 5-10% of the normal dry weather dust conditions.
– The recovery of dust levels will take some time as roads & dusty areas will need to dry out before the dust levels start to increase again.
– During the “recovery” period the first thing that increased is the organic debris & insect debris.
– During extended heavy rain periods the addition of algaecides needs to be increased as the acidic rain addition will encourage the development of algae & other bacterial colony growth. Fortunately these do not add a lot of mass to each sample, but as a percentage this organic material increases a lot as the overall mass remains low.
– Due to the increased humidity of the air production dust will not travel as far as the air density is lower & cannot thus support dust with the result that the precipitation rate gradient is steeper ie. Production dust from a crusher installation will perhaps all precipitate out within 80-100metres (no wind) while in dry weather the material fines could still be in suspension at half a kilometre.
– The d0.50 average particle size of production dust at a given DustWatch position will be finer.
– Remember acid + base = salt & therefore the salinity of the water will increased. This fortunately does not add mass to the sample.

Leave a Comment


NOTE - You can use these HTML tags and attributes:
<a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>